Accessories

The switching voltage regulator SBEC is supposed to act as a current supply for receivers and servos. It makes possible to use a wide range of input voltages from 2S up to 10S Li-XX cells. Setup of the output voltage between 5 and 8V is accomplished by a shorting plug jumper. This implies that the SBEC is also prepared for use with new „higher“ voltage servos. The SBEC is due to its maximum current of 12A suitable for medium and larger models.

The switching voltage regulator SBEC is supposed to function as a current supply for receivers and servos. It enables to use a wide range of input voltages from 3S up to 12S Li-XX cells. Setup of the output voltage between 5 and 8V is accomplished by a shorting plug jumper. This implies that the SBEC is also prepared for use with new „higher“ voltage servos. The SBEC is suitable for medium and larger model due to its maximum current of 40A.

Increaser MPX male / 3x JR conector for MAX BEC 2. Conductor cross section 0.5 mm2.

Assembly kit for installation DUPLEX TU transmit module into Futaba FC-16 and FC-18 transmitters.

Assembly kit for installation DUPLEX TU transmit module into Graupner MC-10 and MC-12 transmitters.

Assembly kit for installation DUPLEX TU transmit module into Graupner MC-19 transmitter.

Assembly kit for installation DUPLEX TU2 transmit module into Graupner MC-14, MC-15, MC-16, MC16-20 transmitters.

Assembly kit for installation DUPLEX TU transmit module into Graupner MX-16s and MX-12s transmitters.

Mounting kit for transmitters Hitec Eclipse 7

Assembly kit is designed for mechanical and electrical connection between JETIBOX profi and RC transmitter.

Connection
red: plus
black: minus
yellow: PPM

Mounting kit for the transmitter DUPLEX TU MULTIPLEX EVO.

Mounting kit for the transmission module Duplex TU2 for switching between the two modules.

Mounting kit for connecting an external siren and headphone output of the DUPLEX TU2.

The programming card ProgCard Pro is determined for adjustments of the Advance Plus controller family (on the side of the programming card you will find the inscription Advance ProgCard plus), as well as for adjustments of the Advance Pro controller (on the side of the programming card you will find the inscription Advance ProgCard Pro).

The DPS 40 (twin electronic switch) and SPS 20 (single electronic switch) are electronic switches mainly meant to switch supply voltages of receivers / servos, regulators, fuel pumps or similar equipment. A big advantage of electronic switches in comparison to mechanical ones is in general their higher reliability as far as vibration resistance is concerned. Another advantage of the electronic switch is given by its practical ability to withstand an unlimited number of switching cycles.

The DPS 40 (twin electronic switch) and SPS 20 (single electronic switch) are electronic switches mainly meant to switch supply voltages of receivers / servos, regulators, fuel pumps or similar equipment. A big advantage of electronic switches in comparison to mechanical ones is in general their higher reliability as far as vibration resistance is concerned. Another advantage of the electronic switch is given by its practical ability to withstand an unlimited number of switching cycles.

The switch SP 06 has been specifically designed for switching purposes of auxiliary functions, such as on board glow plug heating systems and miscellaneous lighting systems etc. in model airplanes, model ships and model cars. The switched loads can be of ohmic, inductive or capacitive character. The switching moment is signalled by a LED.