News

Limited edition of DC/DS-24

We would like to introduce you a special limited edition of ten DC/DS-24 transmitters, which was created for the 75th anniversary of the end of World War II. Unfortunately, the release of this series last year was significantly affected by a global pandemic, which also affected our plans. The limited edition is intended for end customers, collectors and fans of JETI and is created in the spirit of flying legends of World War II. Each transmitter has original design, which was artistically painted directly on the transmitter (Airbrush).

You can find more information and photos on our Facebook profile JETI Model.

Two updates have been released via JETI Studio.

1. REX Assist v1.19 (03/2021)
Airplane pitch with Assist enabled is no longer affected by acceleration (Horizon mode).

2. MVario2 FAI F5J v2.05 (03/2021)
Supports new sensor revision.

Central Box update v1.10

New version of SW v1.10 intended for Central Box 210/220.

-Time interval of the RX alarm was modified to 2s.
-Extension the compatibility for Futaba R7008SB (S.BUS)

The update can be done by the Jeti Studio.

More news »

Firmware update of the DC/DS-16 from a version released prior 1.07.1

DC-16 - DS-16 - Firware Update

If you have the transmitter DC-16 with firmware older than version 1.07.1 (eg 1.05 or 1.06), we recommend you to update to the latest version by following the steps below.

1. Connect TX via USB to PC.

2. In the TX confirm communication with PC.
3. Download the appropriate update file for your language (can be found in the Downloads section). Unzip its contents into a temporary folder at your hard drive.

4. Copy all files from the temporary folder to the root folder of the SD card. When asked, confirm replacement of existing files.

If you are performing an update from version 1.07.1 or newer, at this moment you should disconnect the transmitter from USB and restart it. Otherwise please download a file that contains audio samples of your language version (see links below) and unzip its contents to the root folder of the SD card. Then you should be able to see the newly created folders on the SD card, for example /Voice/en and /Audio/en.

If you have a version 1.05 or older, we recommend deleting the original system sounds located in /Audio folder to take effect of the updated audio files. The updated system audio files are located in /Audio/en folder. In order to keep all your settings please do not delete these files: /Config/Config.jsn, /Config/Calib.jsn. Please keep the /Model folder untouched as well.

5. Switch off and switch on the TX. After that, the update will run.

E-mail Print



Customer support: Phone/Fax: +420 556 802 092 between 8:00 - 10:00 (CET) \| E-mail: jeti@jetimodel.com \| Web: www.jetimodel.com