- Make sure that receivers are set in Normal mode (default from the manufacturer).
- Note down which receiver is the first and which is the second because of later easier identification. Keep the receivers switched off.
- Switch on the transmitter with created model, in Advanced properties - Wireless modes/Trainer menu item select Double Path mode.
- Plug the BIND PLUG interconnection into EXT output of the first receiver. Switch on the receiver. Now the receiver expects a sequency for pairing (in case you have Rx firmware version 3.11 and newer, this period is limited up to 60s).
- Press 3D pushbutton on the transmitter over „Pair primary TX module“ command. As soon as the receiver is identified, you will be asked for confirmation – now push OK button. Switch off the receiver and remove pairing interconnection.
- Plug the BIND PLUG interconnection into EXT output of the second receiver. Switch on the receiver.
- Press 3D pushbutton on the transmitter over „Pair secondary TX module“ command. As soon as the receiver is identified, you will be asked for confirmation – now push OK button. Switch off the receiver and remove pairing interconnection.
- Switch on both receivers. The connection should be established immediately, eventually servo control is allowed.
- Now you can specify additional parameters of the Double Path mode so that the transmitter correctly responds to the signal loss from any of the receivers.

We would like to introduce you a special limited edition of ten DC/DS-24 transmitters, which was created for the 75th anniversary of the end of World War II. Unfortunately, the release of this series last year was significantly affected by a global pandemic, which also affected our plans. The limited edition is intended for end customers, collectors and fans of JETI and is created in the spirit of flying legends of World War II. Each transmitter has original design, which was artistically painted directly on the transmitter (Airbrush).
You can find more information and photos on our Facebook profile JETI Model.

1. REX Assist v1.19 (03/2021)
Airplane pitch with Assist enabled is no longer affected by acceleration (Horizon mode).
2. MVario2 FAI F5J v2.05 (03/2021)
Supports new sensor revision.

-Time interval of the RX alarm was modified to 2s.
-Extension the compatibility for Futaba R7008SB (S.BUS)
The update can be done by the Jeti Studio.