Pairing the transmitter with receivers in Double Path mode (SW 2.01)
The procedure is relatively easy and is similar to pairing of a single receiver...
- Make sure that receivers are set in Normal mode (default from the manufacturer).
- Note down which receiver is the first and which is the second because of later easier identification. Keep the receivers switched off.
- Switch on the transmitter with created model, in Advanced properties - Wireless modes/Trainer menu item select Double Path mode.
- Plug the BIND PLUG interconnection into EXT output of the first receiver. Switch on the receiver. Now the receiver expects a sequency for pairing (in case you have Rx firmware version 3.11 and newer, this period is limited up to 60s).
- Press 3D pushbutton on the transmitter over „Pair primary TX module“ command. As soon as the receiver is identified, you will be asked for confirmation – now push OK button. Switch off the receiver and remove pairing interconnection.
- Plug the BIND PLUG interconnection into EXT output of the second receiver. Switch on the receiver.
- Press 3D pushbutton on the transmitter over „Pair secondary TX module“ command. As soon as the receiver is identified, you will be asked for confirmation – now push OK button. Switch off the receiver and remove pairing interconnection.
- Switch on both receivers. The connection should be established immediately, eventually servo control is allowed.
- Now you can specify additional parameters of the Double Path mode so that the transmitter correctly responds to the signal loss from any of the receivers.